Skip to content
PRODUCT COMPLIANCE & MARKET ACCESSUnited Arab Emirates
UAE market home

United Arab Emirates

ECAS certification UAE: documents, testing and application guide

Understand whether your product needs a UAE Certificate of Conformity, how to prepare the application file and which additional approvals to check.

Request a UAE product review

GoCertify · Sources reviewed

Planning a UAE product launch? Start by showing what the product is, how it will be used and which models you intend to supply. GoCertify helps turn that information into an application plan, organise the evidence and coordinate the assessment through to the certificate decision.

What is an ECAS certificate?

ECAS means Emirates Conformity Assessment Scheme. MoIAT operates the federal service for conformity certificates for products subject to UAE technical regulations. The certificate concerns the products within its approved scope. Its applicability depends on the relevant regulation.

MoIAT regulated-product conformity service

Does your product need ECAS certification?

Describe the product before deciding the approval route. Its function, materials, intended users, electrical ratings and claims help establish which requirements should be checked. A category name or HS code is a starting point for this discussion.

The table gives examples of questions to investigate. It is a preparation aid rather than a definitive list of regulated products. Confirm the category and current requirements with the responsible assessment body.

Does your product need ECAS certification?
Product exampleQuestions for your initial review
Electrical appliances and accessoriesWhat are the ratings and intended use? Are electrical safety reports and any Gulf conformity evidence available?
Cosmetics, perfumes and cleaning productsWhat are the ingredients, use and label claims? Which federal and destination-emirate requirements apply?
Food-contact articlesWhat materials touch food, and under what temperatures, contact times and repeated-use conditions?
Connected or wireless equipmentDoes the model transmit radio signals? Review telecom type approval alongside its product requirements.

MoIAT category-specific technical requirements · GSO low-voltage equipment conformity guidance · TDRA type approval questions and guidance · Dubai Municipality Montaji registration and verification

ECAS document checklist: prepare one consistent product file

MoIAT lists a valid trade licence and an accredited laboratory report among its requirements. Its application form also requests the product category and identifying details such as the brand, description and model.

For an initial GoCertify review, use the folder structure below. We identify the final required documents after reviewing the product and applicable route.

  • Applicant folder — trade licence, contact details and an explanation of the applicant’s relationship to the manufacturer or brand.
  • Product folder — model list, manufacturer and factory details, specifications, ratings and clear product photographs.
  • Evidence folder — complete test reports and existing certificates, including their annexes and lists of covered models.
  • Artwork folder — rating plate, packaging, instructions, warnings and the claims intended for sale.
  • Change log — record differences between models, recent component or formulation changes and any missing evidence.

MoIAT regulated-product conformity service · MoIAT ECAS application form

Check the test scope before arranging new laboratory work

Begin by matching each report to the submitted model and the applicable technical requirements. Ask whether the laboratory’s scope, test methods and report content are acceptable for this application. The category-specific requirements determine which evidence is needed.

A practical review should compare the manufacturer, model identifiers, ratings, photographs and report annexes. List any differences between the tested sample and the intended product. Send those differences for assessment before relying on the report. This can help avoid ordering tests that fail to answer the actual review questions.

MoIAT category-specific technical requirements

How to apply for an ECAS certificate

  1. Describe and classify the product

    Send the model list, specifications, intended use and destination details. We help identify the questions that determine the application route.

  2. Agree the evidence plan

    Review the existing documents with the assessment body, establish the applicable requirements and identify any testing or additional assessment.

  3. Prepare and submit the file

    Organise the approved models, labels and supporting evidence. MoIAT’s digital process includes registration, the application, document upload and fee payment.

  4. Resolve assessment questions

    Keep a record of reviewer queries and revised documents. GoCertify can coordinate responses and track outstanding items with you.

  5. Check the certificate and next steps

    Review the issued scope, product details, conditions and expiry date. Plan any separate approvals and shipment requirements before supply.

MoIAT regulated-product conformity service · MoIAT ECAS application form

ECAS, EQM, G-Mark, TDRA and Montaji: what else should you check?

Build an approval plan for the actual product and destination. The following schemes address different requirements, so check their relationship for your application.

ECAS, EQM, G-Mark, TDRA and Montaji: what else should you check?
Approval or schemeWhat to review
Emirates Quality Mark (EQM)A national conformity mark licensing route that includes a field assessment. Establish whether the product requires or benefits from this route.
G-MarkGulf conformity requirements for covered product groups, including specified low-voltage equipment.
TDRA type approvalThe telecom and radio requirements for equipment within TDRA’s scope.
UAE RoHSApplicable restrictions on hazardous substances in electrical and electronic equipment.
Performance labelsEnergy, water or environmental performance labelling for covered categories.
MontajiDubai Municipality’s registration and verification system for covered consumer products.

MoIAT national conformity mark licensing · GSO low-voltage equipment conformity guidance · TDRA type approval questions and guidance · UAE legislation on restricted hazardous substances · MoIAT performance efficiency labels · Dubai Municipality Montaji registration and verification

Will an ECAS application require a factory audit?

Ask the assessment body to confirm the assessment activities for the applicable category. MoIAT’s regulated-product service provides for technical assessment where conducted, while its national conformity mark licensing service expressly includes a field assessment.

When requesting a quotation, ask for the proposed assessment scope in writing. It should explain whether a factory visit is included and what preparation is expected from the manufacturer.

MoIAT regulated-product conformity service · MoIAT national conformity mark licensing

How long will ECAS certification take, and what affects the quotation?

Plan the work in separate stages: file preparation, any laboratory testing, assessment and the certificate decision. A published processing target for an authority’s service is only one part of this schedule. Ask for an estimate based on the current state of your file.

For a useful quotation, provide the number of models, product differences, available reports, applicant details and intended launch date. Ask the proposal to identify application and assessment charges, laboratory work, any factory visit, GoCertify support and the assumptions behind the estimate.

MoIAT regulated-product conformity service

What should you do after the certificate is issued?

Keep the certificate and its supporting documents together. Record the expiry date shown on the certificate and plan the renewal review before that date. Ask the issuing body how to handle model additions, a new factory or changes to materials, components, formulations or artwork.

For your own checks, compare the product you intend to ship against the approved file. An internal register showing the model, certificate reference, scope and expiry date helps your sales, logistics and compliance teams work from the same information.

MoIAT category-specific technical requirements

How GoCertify helps you obtain the certificate

Send the documents you already have. We can help organise the product information, identify gaps, review the proposed evidence plan and coordinate testing or assessment where required. During review, we follow up on questions and help you prepare clear responses.

The responsible authority or authorised certification body makes the certification decision. Our role is to help you prepare and progress the application with a clear view of what remains outstanding.

Request a review of your product file

ECAS certificate questions

Can I use an existing test report?

Send the complete report and its model annexes for review. Acceptance depends on the relevant requirements and whether the report supports the exact product submitted.

Does a CE mark cover UAE approval?

Provide the supporting reports and declaration as part of the review. The applicable UAE and Gulf requirements still need to be checked for the product.

Can several models share one application?

Prepare a comparison of the models and ask the assessment body to confirm the permitted grouping and required evidence.

Can I enquire before my file is complete?

Yes. Send the product details and available evidence, and tell us which documents are missing so we can help plan the next steps.

Explore our ECAS application support ↗

Get help with your UAE application

Share your model, intended use and any available reports. If you know the destination emirate or whether a UAE importer is in place, include those details.

The responsible authority or certification body decides the application and issues the approval after successful assessment.

Tell us what you need

Share a few details to get started. Fields marked * are required.

Add product photos, specifications or available certificates.

PDF, images, Word, Excel, CSV, TXT or ZIP. Up to 20 files, 10 MB each / 20 MB total.

No files selected.

Once we receive your enquiry, a GoCertify representative will contact you within 24 hours.

Read our Privacy Policy for details about enquiries, files and live chat.

Waiting for the security check. Sending becomes available when it is complete.

If the check remains unavailable, email info@gocertify.net.